Source Audio Soundblox 2 Dimension Reverb - Manual (Page 21)

External Control | 21
Note: Different control assignments can be used for each preset. Don’t
forget to save your settings!
REVERB SEND PARAMETER
There is an additional parameter that does not have a knob associated
with it but can be used with the expression pedal input or with Hot Hand.
To select REVERB SEND as the assigned parameter for external control,
set the CONTROL INPUT to OFF (no LEDs lit). Press and hold the CON-
TROL INPUT button until all three LEDs blink rapidly. The REVERB SEND
is now selected as the parameter to be externally controlled. Next, select
either HH or EXP mode to control the REVERB SEND.
The REVERB SEND controls how much of the guitar input will be sent
in to the reverb effect and how much will be sent to the output. In some
ways, this is similar to the MIX control. However, there is an important
difference in that this control comes before the reverb. By using the RE-
VERB SEND you can selectively send some input signal to the reverb and
bypass the reverb for other input. This allows you to create sounds that
will ring out and sustain with the REVERB SEND on. When the REVERB
SEND is turned down, the sound of the reverb will continue to circulate
while a dry sound can be played over it. The following example will help
explain:
- Continued
HH
MIDI
EXP
CONTROL
INPUT
Press and hold