Source Audio Soundblox 2 OFD Bass microModeler - Manual (Page 9)

Controls: Knobs | 9
DRIVE (B)
The DRIVE controls the level of distortion by adjusting the gain of the
signal going into the distortion section.
MIX (C)
The MIX knob controls the amount of dry, unaffected signal blended in
with the distortion. The clean signal used in this control does NOT have
any TONE SHAPE or NOISE GATE applied. The center point of the knob
is ‘flat’ with no clean signal applied. Turning the knob to the left (toward
‘CLEAN’) will increase the amount of unaffected clean signal in the mix.
Turning the knob to the right (toward ‘HIGH CUT CLEAN’) will increase
the
amount of LO-RETAIN EQ’d clean signal in the mix.
OUTPUT (D)
This adjusts the overall level of the final signal.
TONE (E)
The TONE knob along with the TONE SHAPE control
(F) will cut or
boost the Treble, Mid, or Bass frequencies depending on which mode is
currently selected. All three bands can be set to the default flat (no cut
and no boost) by pressing and holding the TONE SHAPE button
(F) until
it blinks.
Note: Since the Soundblox 2 OFD preset values can differ from the physical
knob positions, it can be useful to determine the positions of the preset
knob values. To do this, start with the pedal in bypass and set all of the
knobs to the full counter-clockwise position. Next, enable the preset
and slowly turn each knob up one at a time until the preset indicator LED
begins to blink rapidly. When this happens, the current position of the
knob matches the saved value.