Source Audio Hot Hand Phaser/Flanger - Manual (Page 9)

DEPTH Knob
The DEPTH knob sets how much of the selected modulation source is used
to modify the frequency responses that are created by the Phaser or Flanger
algorithms.
When using the Hot Hand as the selected modulation source, any signal
present at the
EXPRESSION IN jack is summed with the Hot Hand signal. The
Hot Hand signal is controlled by the DEPTH control, while the EXPRESSION IN
signal is not. Thus the pedal always has the full range of control.
FREQUENCY/DELAY Knob
If the Phaser effect has been selected, the FREQUENCY/DELAY knob acts as an
offset for the Phaser’s frequency response characteristic. Counterclockwise
values will position the typical Phaser notches at lower frequencies than will
clockwise values.
If the Flanger effect is selected, the FREQUENCY/DELAY knob scales all of
the delay times used in the Flanger together. Counterclockwise settings
give short delays, which will have fewer notches in the Flanger frequency
response. Clockwise settings will give longer delays, producing a more
complex sound.
DEPTH
(ALT) FREQUENCY/DELAY
02
03 05
04
00 08
07
06
01
Knobs | 17
Knobs
EFFECT Knob
The EFFECT knob switches between the various different effects. For a
description of each effect, please see page
24 . There are 7 Phasers and 7
Flangers to select from. Some of the selection positions are “between” the
positions marked by the
LED s; these are indicated by having both bracketing
LED s on at the same time. Thus, when Phaser 02 is selected, the LED s for
Phaser 01 and Phaser 03 are both on.
The effects selection jumps past the topmost three LED s, to go directly from
Phaser 07 to Flanger 01 . Going from Flanger 07 to Phaser 01 requires going
through the position labeled CALIBRATE . Simply scrolling through CALIBRATE
does not invoke the calibration function (although it does temporarily mute
the audio.)
The LED s around this knob always display the current MOD SOURCE , as one
of the topmost three LED s. The three choices are HOT HAND , LFO/SEQ , and
ENVELOPE . The selection may be changed by holding down the SELECT pedal,
and moving the knob.
EFFECT
(ALT) MOD SOURCE
ENVELOPE
CALIBRATE
LFO/SEQ
HOT HAND
02
04
06
07
03
02
04
06
07
01
05
03 05
01
FLANGER PHASER
16 | Knobs