Pedals, Saving presets, On/off (left) pedal – Source Audio Hot Hand Phaser/Flanger User Manual

Page 12: Select (right) pedal, 01 : select and edit a preset

SAVE

(ALT) BACKPAGE

PRESET

EFFECT

(ALT) MOD SOURCE

MOTION/SPEED

PRESET

ON/OFF

ENVELOPE

CALIBRATE

LFO/SEQ

INVERT/SEQ ENABLE

DEPTH

(ALT) FREQUENCY/DELAY

HOT HAND

MOTION CONTROLLED PHASER/FLANGER

ON/OFF

SELECT

(HOLD FOR ALT MODE)

FLANGER

PHASER

FLAIL/SLOW

PICK/FAST

STRUM

Pedals

ON/OFF (left) Pedal

Pressing this pedal once engages the effect that is selected. Pressing the
pedal again will turn the effect off and the bypass on. There is an

ON/OFF

LED

right above the pedal that notiﬁes you when the effect is turned on.

Technical Note: In bypass mode, the signal still passes through a unity-gain, high input impedance,
low noise buffer.

SELECT (right) Pedal

The

SELECT

pedal cycles through the 4 presets in a repeating pattern. The

LED

s above this pedal indicate which preset has been selected.

The preset will change when the pedal is released. If the

SELECT

pedal is

held down, it invokes

ALT

MODE

, which changes the function of the

DEPTH

and

EFFECT

knobs to

FREQUENCY/DELAY

and

MOD SOURCE. ALT MODE

also changes

the

SAVE

button into a switch to enter the Back Page parameter editor. When

the

SELECT

pedal is held down long enough to go into

ALT

MODE

, the preset

selection will not advance upon pedal release.

ON/OFF pedal

Select pedal

Saving Presets | 23

22 | Pedals

Saving Presets

The

PRESET

feature of this product has been designed to be simple. This

product allows you to save

different conﬁgurations so that they may be eas-

ily recalled from the standing position. When you receive your product from
the factory, we have selected what we think are 4 useful conﬁgurations. You
may either keep these or replace any of them with your own settings. Should
you wish to return to the original factory presets, see the Restore Defaults
section on page

01 : Select and edit a preset

By stepping on the

SELECT

pedal you can select one of four user presets.

Edit a preset by changing values for

DEPTH

FREQUENCY/DELAY

EFFECT

MOD

SOURCE

MOTION/SPEED

INVERT

. Any time that you change the knob posi-

tions of a given preset, that preset

LED

will blink slowly to indicate that the

preset has been edited.

02 : Press and hold the SAVE button for two seconds

The preset

LED

will blink rapidly to signal that the saving process has begun.

When the light becomes solid, the save process is complete. Note that this
process will over-write any setting that was previously stored in this location.

ADVANCED USER NOTE

It is possible to save different calibration settings for each preset. The procedure is described in the

CALIBRATE

section on page

. Different settings of the Back Page parameters may also be saved

for each preset. See page

SAVE

(ALT) BACKPAGE

PRESET

EFFECT

(ALT) MOD SOURCE

MOTION/SPEED

PRESET

ON/OFF

ENVELOPE

CALIBRATE

LFO/SEQ

INVERT/SEQ ENABLE

DEPTH

(ALT) FREQUENCY/DELAY

HOT HAND

MOTION CONTROLLED PHASER/FLANGER

ON/OFF

SELECT

(HOLD FOR ALT MODE)

FLANGER

PHASER

FLAIL/SLOW

PICK/FAST

STRUM