Sonics VC70T - Manual (Page 16)

OVERLOAD CONDITION
If the Ultrasonic Processor stops working, and OVERLOAD is displayed on the screen,
check for possible causes as outlined in the above paragraph, then set the power switch to
OFF then back to ON to reset the instrument. If the overload condition still exists, contact
the Service Department.
RETURN OF EQUIPMENT
It is suggested that an Ultrasonic Processor in need of repair be sent back to the factory.
In order to receive prompt service; always contact the factory before returning any
instrument. Include date of purchase, model number and serial number. For instruments
not covered by the warranty, a purchase order should be forwarded to avoid unnecessary
delay. Care should be exercised to provide adequate packing to insure against possible
damage in shipment. The Ultrasonic Processor should be sent to the “Service
Department” with all transportation charges prepaid and return of shipment indicated.
Please obtain a Return Authorization Number prior to returning the instrument.
IMPORTANT
I CERTIFY THAT THE ULTRASONIC PROCESSOR AND / OR ACCESSORIES RETURNED
FOR REPAIR ARE FREE OF ANY BIOHAZARDOUS OR RADIOACTIVE MATERIAL AND A
SAFE FOR HANDLING.
RE
DO NOT RETURN ANY EQUIPMENT UNLESS SUCH CERTICATION CAN BE MADE.
16
Go To Top Of Document