Chapter 6, Configuration via telnet, Connection 35 – Solvline PB30xx+ User Manual
Page 35: Chapter 6 configuration via telnet
Portbase User Guide
35
Chapter 6 Configuration via Telnet
1. Connection
Open your telnet client and enter Portbase’s IP address to connect. You need to enter appropriate
username and password to login. Please note that this username and password is used as authentication
method for Web as well. This means if username or/and password has been modified from the telnet
interface, modified values have to be entered to connect to web, and vice versa.
Factory default username: portbase
Factory default password: 99999999
With ‘set’ commands, you can configure Portbase’s settings.
With ‘set view’ commands, you can view current Portbase’s settings.
After changing values, you can see modified values with ‘set view’ commands. But be careful because
these values are not in effect unless you issue a ‘set save’ command. Changes will be discarded if you do
not save current settings.
Command notations:
1) set nw mode [ static / dhcp ]: Either enter set nw mode static or set nw mode dhcp
2) set nw ip