Led / reset 14 – Solvline PB30xx+ User Manual
Page 14
Portbase User Guide
14
Reset button – Portbase reboots if this button is pressed for less than 5 seconds. If
pressed for longer than 5 seconds, Portbase will restore factory default settings.
LED – Operation status of Portbase. Next section describes the meaning of each LED
display status.
LAN port – 8-pin RJ45 jack which is used when connecting Portbase to network
devices such as Ethernet card, hub, and router.
2. LED / RESET
LED
Status
Meaning
On
Power supplied to the device
PWR
(R
ED
)
Off
No power supplied to the device
Off
No active network connection
LAN
(Green)
On
Network activated
Blinking
IP Configuration
On
Normal operation
RDY
(Green)
Off
System error
RS232 On
Serial port set to RS232 mode
RS422 On
Serial port set to RS422 mode
RS485 On
Serial port set to RS485 mode
Green Blinking
Serial data transmitted
Serial Tx/Rx
Orange Blinking
Serial data received
Green Blinking
10baseT connection detected & LAN data transferred
LAN Tx/Rx
Orange Blinking
100baseT connection detected & LAN data transferred
Operation
Result
Pressed for less than 5 seconds
Restart Portbase
Pressed for more than 5
seconds
Restore factory default settings of Portbase. The device will
automatically reboot.