Solberg SRS Series - Manual (Page 11)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 11
*WARNING*
Failure to comply with these instructions
may result in system or equipment
contamination.
4. Securing Element.
A. Place new or cleaned element evenly on base plate by inserting threaded
bolt through bolt hole on the element end cap. Be sure the element seats
properly in the housing top and there is no dirt or particulate present on
sealing surfaces.
B. Secure element with washer and wing nut to end cap and bolt. Element
must be tightly secured. Note: DO NOT over tighten!
*WARNING*
Defective installation may cause system or
pump contamination. Use only genuine
Solberg replacement parts.
Figure C.4.1: Element secure in housing assembly.