Solberg SMConfigurationB(Pg.3-10,11) - Manual (Page 11)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 11
3. Securing SpinMeister ™ to housing.
A. Gently push the SpinMeister
™ and clamp down on the housing inlet
tube. Note: DO NOT push the SpinMeister ™ down as far as it will go,
doing so will damage the SpinMeister
™! The inlet tube should not
exceed top of the SpinMeister ™ internal tube.
B. Tighten hose clamp by using a flat head screwdriver or ratchet and
rotating the screw clockwise.
4. Disconnecting canister top from canister base.
A. Remove housing top by releasing wireform clips and lifting off.
Figure C.3.1: Inlet tube and SpinMeister ™ limit.
Do not exceed
this point!
Figure C.4.1: Clip release direction. Figure C.4.2: Released clip position.
Lift