Snazzy FX DREAMBOAT - Manual (Page 15)

So you take that output and you plug it into the CV in of the NEXT
CO…from that CO you take an X or a Y and you plug it into the CV
of the next CO...you repeat this process of taking an OUTPUT and
plugging it into CO as many times as you have CO’s!
Once every CO but the first has a plug in its CV jack, take an
output from the last CO and plug it into the first CO’s CV input.
it should be a big LOOOOOOOP.
messing with the CV Knobs and the pitch knobs on all 4 sections,
you can get some CRAZY Stuff going on....once again, move
slowly or you will miss some of the best patterns.
One thing you can do is use VCAS to modulate the amount each
CO feeds into the other.....and then maybe even use the
remaining outputs of a different CO as the CV input for that
VCA!!!
Depending on whether or not you have been using
STACKCABLES, you have at least ONE output left over per
section left to stick into another VCO, FILTER, SLEW, sync in, etc
HOWEVER, Stackcables allow you to end up with two outputs per
section....
or they let you take an X and a Y from one of the sections and
stick it into an XY ready Oscilloscope AND use them for signals