Shellab SSI3-2 - Manual (Page 9)

9
MAINTENANCE
Note: Prior to any maintenance or service on this unit, disconnect the power cord
from the power supply.
6.1 Cleaning: Clean with mild soap and water solution, rinse with distilled water and
wipe dry with a soft cloth.
6.2 Disinfecting: Disinfect the incubator interior on a regular basis. to prepare the
incubator, remove the shelves and shelf clips. The fan blade is replaceable.
Stainless steel parts can be sterilized in an autoclave. Decontamination of the
shaker mechanism should be done in place if possible. If further disassembly is
desired, call Customer Service.
The interior and any removed parts can be cleaned with soap and water. To
decontaminate, use a disinfectant that is suitable to your application. DO NOT
use chlorine-based bleaches or abrasives as they may damage stainless steel
surfaces.
When washing the chamber interior; handle the gasket carefully so as not to
impair the positive seal.
6.3 Controls: There is no maintenance required on the main temperature controller,
high limit thermostat or main temperature probe. If the incubator fails to maintain
temperature, see Section 7 Troubleshooting, before calling Customer Service.
Section 6