Shellab SCO12WE-2 - Manual (Page 3)

INTRODUCTION
Thank you for choosing a water jacket incubator. These units are not intended for use at
hazardous or household locations.
Before you use the unit, read this entire manual carefully to understand how to install, operate,
and maintain the unit in a safe manner. Your satisfaction with the unit will be maximized as you
read about its safety and operational features.
Keep this manual on-hand so it can be used by all operators of the unit. Be sure all operators of
the unit are given appropriate training before you put the unit in service.
Note: Use the unit only in the way described in this manual. Failure to follow the guidelines
and instructions in this manual may be dangerous and illegal.
General Safety Considerations
Your incubator and its recommended accessories have been designed and tested to meet strict safety
requirements.
For continued safe operation of your incubator, always follow basic safety precautions including:

Read this entire manual before using the incubator.

Be sure you follow any city, county, or other ordinances in your area regarding the use of this unit.

Use only approved accessories. Do not modify system components. Any alterations or modifications
to your incubator may be dangerous and will void your warranty.
 Always plug the unit’s power cord into a grounded electrical outlet that conforms to national and local
electrical codes. If the unit is not grounded, parts such as knobs and controls may conduct electricity
and cause serious injury.

Do not connect the unit to a power source of any other voltage or frequency beyond the range stated
on the power rating on the data plate inside the door of the unit.

Do not modify the power cord provided with the unit. If the plug does not fit an outlet, have a proper
outlet installed by a qualified electrician.

Avoid damaging the power cord. Do not bend it excessively, step on it, place heavy objects on it. A
damaged cord can easily become a shock or fire hazard. Never use a power cord after it has become
damaged.

Do not position the equipment in such a manner as to make it difficult to disconnect power cord or
coupler.

Do not attempt to move the unit while in operation or before the unit has been allowed to cool.