Shellab SCO12WE-2 - Manual (Page 22)

21
3/ see what other loads are on the wall circuit
Unit will not turn on
1/ check wall power source
2/ check fuse/circuit breaker on unit or in wall
3/ see if unit is on, e.g., fan or heater, and just controller is off
4/ check all wiring connections, esp. around the on/off switch
Unit is smoking – Out of box
Put unit under vent and run at full power for one hour.
Contamination in chamber
1/ see cleaning procedure in Installation
2/ develop and follow Standard operating procedure for specific
application; include definition of cleaning technique and
maintenance schedule.
NOTE: THE TEMPERATURE OF THE GLASS DOOR AND THE INTERIOR CHAMBER
WALLS MUST BE EQUAL TO PREVENT CONDENSATION.
The incubator is designed so that no internal electrical servicing should be required under normal
conditions. If electrical servicing is necessary, it should be performed by qualified service
personnel. FOR PERSONAL SAFETY, ALWAYS DISCONNECT THE POWER BEFORE
SERVICING. For information on where to contact Customer Service, please see the manual
cover.