SeaLand 9400 Series RushFlush Operation Manual User Manual
Page 8

8
Operation
SeaLand 9300-9400 Series RushFlush Toilets
6.3.1 Normal toilet operation -
flush switch and status panel (9400 series)
ADDING WATER TO TOILET BOWL
Press “Add Water” switch (fig .
8
1) until desired water level
is achieved . (Water flow will shut off automatically if switch
is pressed too long to avoid overflow .) More water is usually
added only when flushing solids .
FLUSHING TOILET
Press “Flush” switch (fig .
8
2), then release it . This activates
a powerful water jet action that breaks up and discharges
effluent from the bowl, through the discharge loop and to the holding tank .
Caution – Do Not Flush Foreign Objects!
Flush only water, bodily wastes and rapid-dissolving toilet
tissue . Do not flush wet wipes, sanitary napkins, condoms,
diapers, paper cups, cotton swabs, food, hair or liquids
such as oils or solvents as clogging or damage to the toilet
or toilet system may occur .
Note
Make sure all guests understand toilet operation before use .
6.3.2 Indicator lights
“POWER ON” INDICATOR
On the Dometic flush switch panel, a steady green “Power On” light (fig .
8
3) indicates when
electrical power to the toilet is activated .
“3/4-Full” and “FULL TANK” INDICATOR
The Dometic flush switch panel includes a “Full Tank” light (fig .
8
4) to indicate holding tank
status (if connected to appropriate tank monitoring system) and when it should be pumped out .
When the light is yellow, the tank 3/4 full . When the light is red, the holding tank is full and electrical
power to the toilet automatically shuts off to prevent overfill of the holding tank . After the holding
tank is emptied, the light will turn off and electrical power to the toilet is restored .
8
1
2
4
3