SeaLand 510H Gravity Discharge Toilet - Manual (Page 3)

3
Installation
1. To replace an older toilet, turn off water supply to toilet.
Disconnect water line at toilet water valve. Unscrew floor
bolt nuts and remove toilet. Discard old floor seal and
mounting bolts. The old floor flange may be used if it is
in good condition and fastener holes are positioned as
shown in Figure A. Make sure center of floor flange is at
least 11 inches from back wall (Figure A).
2. If installing new floor flange, make certain that the toilet
mounting bolts align properly with Dometic toilet mounting
pattern (Figure B).
3. Secure flange to floor using at least four flat-head screws
(one each at the front, back, right and left sides of flange)
through countersunk holes. Insert floor bolts into slotted
holes at right and left sides of flange (Figure B).
4. Position floor seal by pressing the floor bolts up through
holes in the seal.
5. Set toilet in place with bolts protruding up through
mounting holes in base (Figure C).
6. Install washers and hex nuts provided with toilet. Snug
nuts down equally with standard 7/16-inch open end
wrench. Install two wood screws provided in two holes at
rear of base. (Figure C).
7. If toilet is being installed in a shower stall, apply a 1/4-
inch bead of glazing compound around the perimeter of
the base (Figure D).
8. Connect water supply line to water valve (1/2 in. NPT)
inlet using appropriate fittings or an extension (Figure E).
9. Turn on water supply and flush toilet to test for leaks.
10. Attach pedal cover to flush pedal (see instructions below)
after making sure there are no leaks at connections.
11. FOR MODEL 210, put base cover in front of toilet base,
aligning flush pedal with opening on side of cover. Push
base cover against front of base, making sure it does not
interfere with flush pedal operation (Figure F).
FOR MODEL 510H, attach
base cover to toilet base in
same manner for model 210,
then fasten two sides together
in back of base using elastic
bands.
Fig. D
Insert
two
wood
screws
in rear
of base.
Fig. B
Fig. C
Fig. E
Fig. F
Fig. A
FRONT
Attaching Pedal Cover
1. Align cover with pedal
and press into place
so that tab locks into
space at rear of pedal.
2. To release cover,
press on tab at back of
pedal and pull off.
COVER