Scientech S200 Vector - Manual (Page 36)

Floating Point Display Mode (Normal vs Scientific): NORMAL
Volts/Joule Channel A: 1.0
Volts/Joule Channel B: 1.0
Attenuation Factor Channel A: 1.0
Attenuation Factor Channel B: 1.0
Active Remote Interface: RS232
IEEE Bus Address (if installed): 4
S200 DEFAULT POWERUP SETTINGS
The first time the S200 is powered up, the following settings have the values shown:
RS232 Baud Rate: 9600 Baud
RS232 Handshake Method: NONE
RS232 Parity: NONE
Range: 1
Autorange: OFF
Mode of Operation: ENERGY MODE
Pulses per average for average energy mode: 10
Backlight Switch: OFF
Tune Bar Display: OFF
Floating Point Display Mode (Normal vs Scientific): NORMAL
Volts/Joule: 1.0
Attenuation Factor: 1.0
Active Remote Interface: RS232
IEEE Bus Address (if installed): 4
AD30 DEFAULT POWERUP SETTINGS
The first time the AD30 is powered up, the following settings have the values shown:
RS232 Baud Rate: 9600 Baud
RS232 Handshake Method: NONE
RS232 Parity: NONE
Range: 1
Autorange: OFF
33