Scientech S200 Vector - Manual (Page 15)

The AVG ENERGY mode in the D200PC only exists in channel A - the pyroelectric channel.
Power Mode
Average Power Mode - Models S200, D200P, D200PC (channel A)
Select the appropriate range for the average power level to be measured. The average power mode displays
the average power (watts) of repetitively pulsed lasers Minimum rep rate of 10 pps). To enter into the average
power mode, follow the same procedure as the energy mode except press the SELECT button when the
AVG POWER annunciator appears.
Power Mode - Models D200C,
D200PC (channel B)
The power mode displays the average power level of repetitively pulsed lasers or the power level of CW
lasers. Enter into the power mode by following the same procedure as energy mode only press the SELECT
button when the POWER annunciator appears.
Volts Mode
Volts Mode - Models S200, D200P, D200PC (channel A)
The volts mode displays the peak voltage of the pyroelectric joulemeter sensor. To enter into the volts mode,
follow the same procedure as energy mode except press the SELECT button when the VOLTS annunciator
appears.
Function Menu Cycles
Pressing the FUNCTION button begins menu cycles which allows the selection of channel A, channel B or
ratios (dual channel models), statistics mode, tune bar, log units (ratio mode), display in scientific notation,
and digital output configuration. The menu cycles are as follows:
Model S200: STATS TUNE BAR E REMOTE
Press the FUNCTION button to begin the above menu cycle. Press the SELECT button to activate the
statistics mode (STATS), the analog tune bar (▄ ▄ ▄ ▄ ▄ ▄), display in scientific notation (E), digital output
configuration (REMOTE). To change any condition, re-select it. For example, if the tune bar is active and you
want to de-activate it, press the FUNCTION button to start the menu cycle, then press SELECT when the
tune bar annunciator appears.
Model D200P: CH AB RATIO
STATS TUNE BAR LOG E REMOTE
TRIG A TRIG B
Channel Selection: Press the FUNCTION button to begin the above menu cycle. Press the SELECT button
when the CH AB RATIO annunciator appears in the display. This begins the cycle of CH A CH B RATIO A/B
RATIO B/A. Press the SELECT button when the desired annunciator appears to activate channel A
12