beautypg.com

40kmc / 40kmq, Table i: unit protection devices, Display of selected functions – Carrier 40KMC------301 User Manual

Page 6: Up down

background image

GB - 5

40KMC------310/ 40KMQ------310

E N G L I S H

“Room controller” general information and characteristics

Table I: Unit protection devices

WARNING:
During heat pump operation the unit will undergo several defrost cycles to remove ice that might collect on the outdoor unit in very low ambient
temperatures. In these cycles, the indoor fan will be automatically off and cannot operate until defrost cycle is completed.

System

Type of protection

Effect of protection

Operation mode

When on

Cold draft prevention

Indoor fan off

Heating in

During unit operation

heat pump mode

Heat pump

Defrost cycle

Indoor fan off

Heating in

During unit operation

heat pump mode

Indoor coil

Compressor off

Cooling

During unit operation

Cooling only

freeze protection

and

heat pump

Against frequent

Compressor

Cooling or heating

At unit start-up or

compressor cycling

time delay

in heat pump mode

change of operating mode

A = Display readout
B = Increase

temperature /
change louvre
setting button

C = Decrease

temperature /
change louvre
setting button

D = Fan selection

button

E = Mode selection

button

C

D

E

A

B

Characteristics

Single unit operation:

Ability to control one unit only.

Grouping:

Ability to control 2 to 6 units with one Room Controller.

Operating modes:

Off, Heat, Cool, Dry, Auto, and Fan only.

Fan speeds:

Low, Medium, High, and Auto.

Louver control:

Auto and swing.

Desired temperature:

Range between 17 and 32 °C (63 and 90 °F).

Room Thermistor Override:

Allows to use air sensor located in the Room Controller instead
of the one located into the unit.

Diagnostics:

Detects the fault of air sensor in the Room Controller.
“A1” shown on the screen indicates this anomaly.

UP

” and “

DOWN

” buttons

Buttons for raising or lowering the temperature or for selecting
the

AUTO

or

SWING

louver mode.

MODE

Button for operation mode selection.

FAN

Button for fan or louvre selection.

ቪ ቩ ቨ

Display of selected functions

ቢ Automatic

ባ Off

ቤ Temperature

selected / room
temperature

ብ Set temperature

ቦ Operating

position of the air
louvre

ቧ Fan speed

ቨ Heating

ቩ Cooling

ቪ Dehumidification

only

up

down

This manual is related to the following products: