Sceptre X20WG-NAGA2 - Manual (Page 29)

SCEPTRE X20 Page29
$ " $ " $ " $ "
Item Standards
Vertical
Scanning
Frequency
(Hz)
Horizontal
Scanning
Frequency
(kHz)
1 720x480i 29.97 15.73
2 720x480P 59.94 31.46
3 1280x720P 60 45
4 1920x1080i 30 33.75
5 1920x1080P 60 67.5
*Through DVI only
Problem Possible solutions
DISPLAY IS
UNCLEAR AND
UNSTABLE To stabilize and clarify your display, use the AUTO ADJUST
function or change the resolution to the display’s optimal
setting 1680 X 1050 at 60Hz, then AUTO ADJUST.
THERE IS NO LCD
DISPLAY or SCREEN
SAYS NO VIDEO Make sure you switched to the correct source. Check both
sources to see video is on the other source. Check your video
cable. It might be corrupt. Swap out the video cable for another
one to see if the monitor will work. Check your power plug.
See if it is fully plugged in on both the monitor and the wall.
MONITOR SAYS
“SIGNAL OUT OF
RANGE” If you have a CRT monitor, please connect the CRT monitor to
the computer and change the refresh rate down to 60Hz via
your video card’s display settings menu. After the setting of
60Hz has been change you can then use the LCD on the
computer.
1. To change the setting go to display settings by right
clicking on your desktop