Sceptre X20WG-NAGA2 - Manual (Page 20)

Page20 SCEPTRE X20
& * + $ - & $ , & * + $ - & $ , & * + $ - & $ , & * + $ - & $ ,
1. Make sure the power of X20 LCD MONITOR is turned off.
2. If you were previously using a CRT (bulky) monitor , please hook up
your old monitor first and make sure your refresh rate is set to 60 Hz
frequency before using the X20 LCD MONITOR. You can find the refresh
rate information and change it by RIGHT CLICKING on the desktop with
nothing selected. After you have right clicked, select the PROPERTIES
option. Click on the SETTINGS tab. Click on the ADVANCED button. Click
on the MONITOR tab. In that tab, change the refresh rate to 60Hz and click
on APPLY. After the refresh rate changed, please shut down the computer
and monitor.
3. Obtain the VGA cable and connect to the VGA connection on your PC.
Connect the other end of the cable to your X20 LCD MONITOR.
4. Turn on the power of both the X20 LCD MONITOR and the PC.
Please Note :
The PC’s clearest picture is produced under 1680x1050 at 60Hz.