Centro 6800 - Manual (Page 14)

13
13a. Position the Sear Zone burner (DD) through the open-
ing in the left side shelf (DA).
13b. Make sure that the Sear Zone burner (DD) engages the Sear
Zone burner valve (CC), gas jet, as shown in figure B.
13c. Assemble the Sear Zone burner (DD) to the Sear Zone sup-
port frame (DC), at the 4 points indicated in figure C.
13d. Feed the Sear Zone Electrode wire (DE) from underneath
the Sear Zone burner (DD), through the small opening on
the right side of the Sear Zone support frame (DC). Align
and assemble the Electrode using the self tapping screw
provided, as shown in figure D.
ASSEMBLY INSTRUCTIONS
DD
DD
DC
DE
12
#8 - ø5 Washer (x4)
#9 - NO10 Nut (x4)
#6 - NO. 10x10 Screw (x4)
#10 - ST4.2x20 Tapping Screw (x1)
#7 - ø5 Lock Washer (x4)
A
B
C
D