Sandia Aerospace SAC 7-35 User Manual
Page 26
The configuration menu presents all the adjustable parameters. To change a parameter enter a single character
followed by return. For example:
Select an Option to Configure: 1
Select the number 1 and press Enter. This would change the Port1 Format parameter. The prompt will then
change to:
1. Garmin Z
2. King D
3. Garmin G
4. ADS-B
5. Disabled
Select a Navigation System:
Then enter a selection (or value) followed by enter. For Example:
Select a Navigation System:1
The status lines will show the new configuration. (Garmin-Z is represented by a Z):
Serial > Z:1200 G:38400 S:1200 E:19200 Mode>> IAS_Cutoff=40 Arinc=A DASH -00
Trim >> Alt:-1270:1270 IAS:0:10 Baro:-1.27:1.27 OAT:.0:.0 Hdg:000:0
Fuel >> K=130000:500 0s delay 6.02lb/g
After all the configuration parameters are programmed, select x
Enter again to record changes or Escape to go back. The status lines should be recorded for future
reference. Then the DIN to Serial cable adapter removed. Upon a power cycle, the new parameters will
be set into the SAC 7-35.
Note: Record and save the Status lines for future
use. They can be use to reprogram the unit should
service or replacement be required.
SAC 7-35 S/N ______________ A/C N# ___________________
Serial > ___ : ________ ___: ________ ___ : ________ ___ : ________ Mode>>IAS_Cutoff= _____ Arinc= ____ DASH _______
Trim >> Alt: ________ : ________ IAS: _____ : _____ Baro: ________ : ________ OAT: _______ : _________ Hdg: _____:________
Fuel>> K = ________________:________________ ________S delay _________________lb/g
25
Note: The SAC 7-35 must be reset by cycling
power, after configuration is completed