PS Engineering PDA360EX Pilot’s Guide - Manual (Page 7)

202-760-0100 Page 7 Feb. 2011 PAR100EX Pilot Guide
Quick reference PAR100EX Operation
This pull-out section covers advanced operation of the
PAR100EX.
Frequency Selection
Turn the large (outer) knob to change the frequency whole MHz, and
the smaller, inner knob to change the .100 MHz frequency.
Push the small knob momentarily to transfer standby frequency to the
active frequency.
Radio Volume and Radio Squelch
To change the radio volume, or defeat the automatic radio squelch,
push and hold the frequency-select knob for one second, until the dis-
play changes to the volume and squelch menu.
Turn the large knob to turn the radio squelch on or off (to listen for
weak signals), and the small knob to adjust the radio receive audio
level. You can push the knob again to return to the frequency display,
or the display will revert automatically after five seconds without any
activity.
Monitor Mode
When interfaced with the M760REM VHF COM radio as Com 1, the
standby frequency can be monitored by holding the C2 Receive but-
ton for the Microair for more than one second (or until the MON indi-
cator becomes active).
Push
momentarily
Push/hold for
more than one
second