Proto-X FPV - Manual (Page 8)

8
SUN SHIELD
To assemble and install the sun shield, start by
laying the parts out as shown:
Snap each side panel together one at a time.
Then slide the lower base in place.
Snap the completed sun shield onto the
transmitter by placing the two lower lugs into the
two lower mounting holes of the screen. Rotate
and snap the top lug into the upper hole to
compete the assembly.
ADVANCED PERFORMANCE SETUP
SERVO REVERSING: If you would like to reverse any control function due to
personal preference, then follow the instructions below.
Press down on the right stick for 1 second to enter the settings menu. Move the
stick up or down to choose SET REVERSE, scroll to the right, and then scroll
up and down to select the channel you wish to reverse. Press the stick down for
2 seconds to exit.
SENSITIVITY SETUP: If you would like to change the sensitivity of any of
the stick functions follow the instructions below. A higher setting value will enable
larger/faster movements while a lower value setting will cause a smaller/slower
response.
Press down the right stick for 1 second to enter the menu. Move the stick up or
down to choose SET SENSITIVITY. Push the stick to the right and press the
elevator/aileron/rudder trim to set sensitivity. Push the stick to the right to exit.
Press the elevator stick down for 2 seconds to exit.