Pro Boat PRB3800 - Manual (Page 7)

7
Adjusting the Transmitter
Note: Refer to the radio instructions for
specific information on transmitter setup.
Adjust both the Throttle and Steering trims to
the center position.
Turn on the transmitter, then the receiver
power switch.
Adjust the rudder trim knob so that the
rudder is centered prior to operation. You
may adjust this control to make the boat run
straight during operation.
Ensure the antenna is properly placed
through the antenna tube. It may be
necessary to slightly pull the antenna
tube out to make certain the radio range
is sufficient.
Checking the Radio System
Throttle
Trim
Steering
Trim