Pro Boat PRB3650 - Manual (Page 7)

7
 9. Place the motor battery in the hull.
 10. Confirm that the ESC on/off switch
is in the "OFF" position and connect
the battery to the battery plug from
the speed control.
 11. Turn on the transmitter, then the
ESC on/off switch. The radio system
is now searching for the receiver it is
bound to. Once located, the LED on
the receiver will illuminate and allow
rudder operation.
To engage the motor, actuate the on/
off switch again. The ESC will beep
until you pull the throttle trigger
to full throttle and return it to the
neutral position.
 12. Check the operation of the
steering in relationship to the
steering wheel. When the wheel is
rotated clockwise, the thruster must
move right as shown. If not, follow
the instructions from the radio to set
the servo reversing for the steering.
You may increase or decrease the
amount of steering authority by
adjusting the Steering Dual Rate
(S.T. D/R) on the transmitter.