Pro Boat PRB3650 - Manual (Page 5)

5
Required Equipment
and Accessories
Transmitter (included)
AA battery (4)
Motor battery (charged) (included)
Hook and loop tape (included)
 1. Plug the charger into the proper
wall receptacle then the battery into
the charger and let it charge for
approximatly 2 hours. Charge time will
be less if the battery is not completely
discharged. Monitor the battery's
temperature closely during charge.
If the battery becomes warm to the
touch, the battery is fully charged.
Note: Do not leave the battery
connected more than 2 hours or
permanent damage to the battery
and charger may occur. Never charge
on or near flammable surfaces or
materials.
Note: The PRB1203 12V DC Car
charger may be purchased separately
to allow charging from a car or
boat. This charge will charge the
battery in less than an hour and will
automatically stop charging when the
battery is fully charged.
 2. Slide the cover from the bottom
of the transmitter to access the
battery holder.
 3. Install the four AA batteries in the
battery holder. Match the polarity of
the batteries to the molded markings
in the battery holder.
Basic Assembly