PRG Mbox Designer User Manual v3.6.1 - Manual (Page 142)

134 MBOX ® MEDIA SERVER USER MANUAL
MBOX REMOTE OPERATION
About MBOX Remote
The MBOX Remote application is used for remote control and monitoring of the MBOX Designer
application. The application is included with the MBOX Designer software and can also be used on any
Mac® computer (running Snow
Leopard® OSX 10.6.7 or greater ) to monitor from a remote location.
MBOX Daemon
Before discussing the MBOX Remote application, it is important to note that MBOX Daemon software is
required on all servers to enable remote feedback to both MBOX Remote and to CITP/MSEX-enabled
devices. When MBOX Designer launches, it will automatically launch the last version of MBOX Daemon
used on that computer.
To set the network port that MBOX and Daemon will use to communicate with external monitoring
devices (like Remote or CITP-enabled consoles and visualizers), use the CITP pop-up on the MBOX Setup tab as
shown below:
Training Video: Mbox Media Server Training Video Chapter 7: Daemon Application
Set Network
Synchronization
Port
Set Network
CITP Port