PRG OHM User Manual 1.12 - Manual (Page 19)

OHM™ LIGHT USER MANUAL 17
Navigation Within 'Maintenance' Menu
If any button is pressed, the current control screen will re-open.
This example shows the 2900K CCT control screen.
Note: When OHM is powered down via the mains, the MMI will switch OFF. When OHM is powered up, the fixture will
remember the last MMI settings:
Intensity, CCT, DMX Mode and DMX Address .
DMX Controls
Once the DMX is connected to OHM via the 'DMX In' port, the fixture can be controlled by the DMX. The MMI will
display the DMX control screen as shown below:
[1] DMX Mode Setting: The 1st line displays current
DMX Mode.
[2] Current DMX Address: The 2nd line displays
current DMX Address.
[3] New DMX Address: The 3rd line displays a new
DMX Address, should the user want to change the
current DMX Address. The new address can be
altered by using the Rotary Knob.
[4] Black Button: Once the new DMX Address has
been altered via use of the Rotary Knob, the user
can confirm this change by selecting the Black
Button. This will change the Current DMX Address
to the value chosen in the New DMX Address.
[5] Red Button: This button and all others remain
inactive when connected to a DMX
M a i n t e n a n c e
S E L E C T
6
M a i n t e n a n c e
When the Maintenance option is selected, OHM functions in Maintenance Mode. This mode allows
the connection to the internal electronics via use of the Communications Port. Software updates will
be carried out when in this mode.
W h i t e C C T
2 9 0 0 K S t u d i o
O N 1 0 0 % D M X 4 5 1 M E N U
M o d e = S t a n d a r d
C u r r e n t D M X 0 0 1
N e w D M X 0 0 3
S E L E C T
4 5 3
1 2