beautypg.com

Potter RA-7692 User Manual

Page 7

background image

Annunciator Manual • 8910224 • Rev C • 6/09

7

End-User Options

The RA-7630 Annunciator provides adjustments to the keypad that

can be made by the end-user. Below is a description the options

and instructions on their operation.
To access the User Options portion of the annunciator, press and

hold the Back Arrow and COMMAND keys for two seconds.

The keypad display changes to SET BRIGHTNESS. Press the

COMMAND key to display the next option or the Back Arrow key

to exit the User Options function.

Backlighting Brightness

This option allows the user to set the brightness level of the

keypad’s Liquid Crystal Display (LCD), AC LED, and the Green

keyboard backlighting. At the SET BRIGHTNESS display, use the

left Select key to lower the keypad brightness. Use the right Select

key to increase the brightness.
Note: If the brightness level is lowered, it will temporarily revert

back to maximum intensity whenever a key is pressed. If no keys

have been pressed and the speaker has not sounded for 30 seconds,

the user selected brightness level is restored.

Internal Speaker Tone

This option allows the user to set the tone of the annunciator’s

internal speaker. At the SET TONE display, use the top left Select

key to make the tone lower. Use the right Select key to make the

tone higher.

Volume Level

This option allows the user to set the volume level of the

annunciator’s internal speaker for key presses and prewarn

conditions. During alarm, trouble, and prewarn conditions, the

volume is always at maximum level. At SET VOLUME LEVEL,

use the left Select key to lower the keypad volume. Use the right

Select key to raise the volume.

Model Number

The LCD displays the annunciator’s model number as well as the

firmware version and date. The information cannot be changed by

the user.

Keypad Address

The LCD displays the annunciator’s current address as

programmed the Keypad Address option discussed below. The

information cannot be changed by the user. Press the Back Arrow

key to exit the User Options function.

This manual is related to the following products: