Potter RA-7692 - Manual (Page 11)

Annunciator Manual • 8910224 • Rev C • 6/09 11
System Test
Function: Tests the battery, alarm bell or siren, and communi cation
to a central station. The System Test function begins automatically
as soon as you select it.
1. Access the User Menu. Press the COMMAND key until SYSTEM
TEST? displays.
2. Press any Select key. The system test begins automatically and
the annunciator displays:
1. BELL SOUNDING during a two second bell test, then:
2. BATTERY - OKAY or BATTERY - TRBL to indicate the
condition of the battery, then:
3. * TRANSMIT TEST and ATTEMPT NO : 1 during the
transmit test, then:
4. * TRANSMIT OKAY or TRANSMIT FAILED to show the
results of the transmit test, then:
5. TEST END to indicate the System Test is complete.
6. You can cancel the transmit test by pressing the Back
Arrow key.
* The transmit tests are not applicable for local systems.
Fire Drill
Function: Allows you to practice fire drill evacuations.
1. Access the User Menu. Press COMMAND until FIRE DRILL
displays.
2. Press any Select key. The annunciator displays SURE? NO YES.
Press the Select key under YES. The system rings the bells until you
enter the user code or until the programmed bell time expires.
User Codes
Function: Allows you to change the user code number you enter at
the keypad.
Note: The user code must always have 4 digits.
1. Access the User Menu.
2. Press COMMAND until CODE NO: * * * * displays.
3. Press any Select key. The keypad displays CODE NO: –.
Enter a new 4-digit user code. If the code you entered is a special
service code used internally by the system, the keypad displays
ALREADY IN USE. You must enter a different user code.