Perfect Aire NP10000 - Manual (Page 14)

CARE AND MAINTENANCE
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
an authorized repairman.
IMPORTANT:
1. Air filter
- Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust.
- Removal
This unit has two filters. Take the upper and lower filters out
along the arrow direction as shown in Fig. 23.
- Cleaning
Wash the air filter by immersing it gently in warm water
(about 104 O F/40 O C) with a mild detergent. Rinse the filter
and dry it in a cool, dry place.
- Mounting
Install the upper and lower air filters after cleaning as shown
in Fig. 24.
2. Unit enclosure
- Use a lint-free cloth soaked with mild detergent to clean
the unit enclosure. Finish by using a dry, clean cloth.
3. Unit idle for a long time
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet . Place the open end of the hose
directly over the drain area in your basement floor or over a
shallow pan (if no floor drain is available.) (See Fig. 21 & 22.)
- Remove the plug from the bottom drain outlet; all of the water
in the bottom tray will drain out (See Fig. 22.)
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
from forming.
- Stop the appliance and unplug it. Wrap the cord and
bundle it with the tape. Remove the batteries from the
remote control.
- Clean the air filter and reinstall it.
- Disconnect the exhaust hose. Keep it safe and cover the
window (wall) hole with the adaptor cap or remove slider
kit from the window (wall) completely.
NOTE: The upper grille and upper air filter are connected and
can be separated. The same is true for the lower grille
and lower air filter.
13
Fig. 23
Fig. 24
Upper filter
(install)
Upper filter
(take out)
Lower filter
(take out)
Lower filter
(install)