Perfect Aire PES5000 - Manual (Page 8)

Low
Auto
Med
High
TEMP/TIMER
Auto
Cool
Dry
Fan
On
Off
Sleep
Timer
Check
Filter
TIMER: AUTO START/
STOP FEATURE:
Press “Timer”
button
DO THIS:
NOTE: TIMER button
First press the “Timer” button. The indicator light
beside the word “On” will illuminate indicating the Auto
Start program is on.
Press or hold the Up or Down Temp/Timer arrows to
change the Auto time by 0.5 hour increments, up to
10 hours, then at 1 hour increments up to 24 hours.
The control will count down the time remaining until start.
The selected time will register for 5 seconds and the
system will automatically revert back to display the
previous temperature setting.
When the “Timer On” is displayed, press the “Timer” button
again and the “Timer Off” indicator light illuminates. It
indicates the Auto Stop program is initiated.
Turning the unit on or off at any time or adjusting the timer
setting to 0.0 will cancel the Auto Start/Stop function.
TO USE THE ENERGY
SAVER FEATURE:
Press the
“Energy Saver”
button
DO THIS:
SLEEP FEATURE:
Press “Sleep”
button
DO THIS:
In this mode the selected temperature will increase
(cooling) or decrease (heating - units with heater only)
by 2 O F/1 O C 30 minutes after the mode is selected.The
temperature will then increase (cooling) or decrease
(heating - units with heater only) by another 2 O F/1 O C
after an additional 30 minutes. This new temperature
will be maintained for 6 hours before it returns to the
originally selected temperature. This ends the Sleep
mode and the unit will continue to operate as originally
programmed. The Sleep mode program can be
cancelled at any time during operation by pressing
the “Sleep” button again.
NOTE: SLEEP button
To operate on “Fan” only (not available on all models):
Use this function only when cooling is not desired,
such as for room air circulation or to exhaust stale
air. (Remember to open the vent during this function,
but keep it closed during cooling for maximum cooling
efficiency.) You can choose any fan speed you prefer.
During this function, the display will show the actual
room temperature, not the set temperature as in the
cooling mode.
NOTE: ENERGY SAVER button
To operate on “Dry” mode:
In this mode, the air conditioner will reduce air humidity.
If the space is a closed or sealed area, some degree
of cooling will continue.
This function is available on “Cool,” “Dry,” and “Auto”
(only Auto-Cooling and Auto-Fan) modes. In this
mode,the fan will continue to run for 3 minutes after the
compressor shuts off.The fan then cycles on for 2
minutes,at 10 minute intervals, until the room
temperature is above the set temperature, at which time
the compressor turns back on and cooling starts.
AIR CONDITIONER FEATURES (CONTINUED)
TEMP/TIMER
On
High
Fan
Fan Mode
Energy
Saver
Follow
Me
Low
Auto
Med
High
TEMP/TIMER
Auto
Cool
Dry
Fan
Fan Mode
On
Off
Sleep
Timer
Check
Filter
Energy
Saver
Follow
Me
7