Perfect Aire PAC5000 - Manual (Page 10)

9
SECURE THE ACCORDION PANELS 4 B. Slide the free end " " section of the panel
directly into the cabinet as shown in Fig. 2.
Slide the panel down. Be sure to leave
enough space to slip the top and bottom of
the frame into the rails on the cabinet.
Fig. 2
" "section
C. Once the panel has been installed on the
side of the cabinet, make sure it sits securely
inside the frame channel by making slight
adjustments. Slide the top and bottom ends
of the frame into the top and bottom rails of
the cabinet. Fig. 3.
D. Slide the panel all the way in and repeat
on the other side.
Top Rail
Bottom Rail
Fig. 3
A. Keeping a firm grip on the air conditioner,
carefully place the unit into the window opening so
the bottom of the air conditioner frame is against
the window sill (Fig. 5). Carefully close the window
behind the top rail of the unit.
Fig. 5
NOTE: Check that air conditioner is tilted back
approximately 5/8" to 3/4" (tilted about 3 O to 4 O
downward to the outside). If, after proper
installation, condensation does not drain from the
overflow drain hole during normal use, adjust slope.
B. Extend the side panels out against the window
frame (Fig. 6).
window
frame
Fig. 6
INSTALL SUPPORT BRACKET 5
A. Place the frame lock between the frame
extensions and the window sill as shown in Fig. 7.
Drive 3 / 4" (19 mm)or 1 / 2 "(12.7 mm) locking
screws through the frame lock and into the sill.
NOTE: To prevent window sill from splitting,drill
1 / 8" (3 mm) pilot holes before driving screws.
Fig. 7
NOTE: If storm window blocks AC, see Fig. 11.
Top Rail
Bottom Rail
Top left
Top right
Fig. 4
Wooden Windows
INSIDE
OUTSIDE
Approx. 5/8" to 3/4"
Measure from the cabinet edge
INSTALLATION INSTRUCTIONS (CONTINUED)