Chicago Electric 67616 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. Item 67616
Operating instructions
Read the EntiRE impORtant SaFEtY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO pREVEnt SERiOuS injuRY FROm aCCiDEntal OpERatiOn:
Release the trigger and unplug the tool from its electrical outlet
before adjusting the tool or installing accessories.
installing auxiliary handle
Figure B
Hex Bolt (3) Depth Gauge (1)
Gear Box (11)
Clamping Band (2)
Chuck (7)
Auxiliary
Handle (4)
1. Insert Clamping Band (2) over gear housing behind
Chuck (7) with required handle orientation. Slightly
rotating Clamping Band will enable the two tabs
on housing to align with recesses around clamp
face. Pull clamp tightly against housing and turn
Auxiliary Handle (4) to tighten clamp. See Figure 1.
2. Depending on whether left or right-handed use
is needed, turn the Clamping Band around until
the Auxiliary Handle (4) is on the correct side.
3. Securely tighten the Hex Bolt (3) until Auxiliary
Handle is fastened securely onto Drill.
inserting Drill Bit
The Hammer Drill is equipped with a keyed
Chuck. Follow these steps to insert bit:
1. Insert the Chuck Key (52) into the Chuck and turn
counterclockwise to open the mouth of the Chuck.
2. Insert the hammer bit or the drill bit (not
included) all the way into the Chuck.
3. Turn the Chuck Key clockwise to tighten the Chuck
on the bit. When not in use, the Chuck can be
stored in the holder on the Key Sleeve (51).
Sa
FE
tY
Op
ER
ati
O
n
m
aint
Enan
CE
SE
tup