Using the remote’s vcr buttons, Record (clear) button, Rewind button – Philips COLOR TV 25 INCH TABLE User Manual

Page 29: Pause button, Tv-vcr button, Play button, Stop button, Fast forward button, Channel scan buttons, Number buttons

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

sing

the

emote

’

VCR

uttons

hen using the TV remote
with a VCR, first make cer

tain it is set to control your VCR
(by the REMOTE CODE or
SEARCH method - see earlier
section).

LBEOINJ

Press the VCR System but

ton on the remote.

Point the top of the remote

toward the front of the VCR
(remote sensor window) when
pressing buttons.

Record (Clear) Button

Hold the RECORD button down, and
then press the PLAY button to begin
a VCR recording. The CLEAR button
can be pressed to erase incorrect data
when programming VCR functions.
The Clear button can also be pressed
to reset the VCR’s real time counter.

Rewind Button

Press to rewind tapes. For some
VCRs you may need to press STOP
button first then REWIND. In play
back mode hold button down to view
picture moving rapidly in reverse.

Pause Button

Press to temporarily stop the tape
during a playback or recording. Press
again to release Pause.

TV-VCR Button

Press to the VCR position ("VCR"
indicator on the VCR will light) to
view the playback of a tape. Press
again to place in the TV position
("VCR" indicator on the VCR will go
OFF) to view one program while
recording another program.
When used with the TV the TVA^CR
button works as a source button.
Each press cycles the TV between
channels 3 and 4; or the VCR/AUX
Input mode. It is a quick one-button
way to select these channels and
modes (without directly entering the

TV's Menu system.)

Play Button

Press to playback a tape. Hold down
after pressing the RECORD button to
start a recording.

Stop Button

Press to stop the tape.

Fast Forward Button

Press to rapidly advance the tape. For
some VCRs you may need to press
STOP first then FF. In Playback
mode hold button down to view the
picture moving rapidly in the forward
direction.

Channel Scan Buttons

Press to scan up or down through
VCR chaimel numbers.

Number Buttons

ft-ess buttons for direct VCR charmel
selections.

VCR System Button

Press to send remote commands to
the VCR.

Power Button

Press to turn the VCR ON and OFF.

mart

Remember, the VCR but

tons on the remote will not

operate your VCR if those fea
tures are not already found on
your VCR remote control.

Note: All VCR functions (particu
larly Search, Rewind, Fast
Forward, etc.) will operate the
same as with the original VCR
remote conhol provided with the
VCR.