Philips AZ240717 - Manual (Page 9)

fiMMiBtJESHOSTIWG _ __________
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
center.
WARNING: Under no circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEM __________
- POSSIBLE CAUSE
• REMEDY
No sound/power
_ CD playback does not work
- VOLUME is not adjusted.
• Adjust the VOLUME.
- Headphones are connected.
• Disconnect headphones.
- Batteries are exhausted.
• Insert fresh batteries.
- Batteries are incorrectly inserted.
• Insert the batteries correctly.
-
Pwer cord is not securely connected.
• Connect the power cord properly.
- Batteries loaded but power cord still plugged
in and connected.
• Pull out the power cord from the MAINS
outlet and the set.
Reversed left and right sound/no sound
from one speaker____________ ___________________
- Speakers incorrectly connected
• Connect properly: L to left, R to right
Poor bass sound
- Speakers not in phase.
• Connect speaker poles correctly,'+' pole (red
marked wire} t o ‘ - ' p o l e (black/unmarked
wire) to
- CD is badly scratched or dirty.
• Replace or dean the CD, see Maintenance.
- Laser lens steamed up
• Wait until lens has acclimatized
The CD skips tracks
- CD is damaged or dirty.
• Replace or clean the CO.
- PROGRAM/SHUFFLE is active.
• Switch off the PROGRAM/SHUFFLE function
Poor cassette sound quality___________________
- Dust and dirt on the heads, capstan or
pressure roller.
• Clean the heads etc,, see Maintenance.
- Use of incompatible cassette types (METAL
or CHROME}.
• Only use NORMAL (lEC I) for recording.
Recording does not work_____________________
- Cassette tabfs} may be broken out.
• Apply a piece of adhesive tape over the
missing tab space.
Remote control does not function properly
- Batteries are exhausted.
• Insert new batteries,
- Batteries are incorrectly inserted.
• Insert batteries correctly,
- Distance or angle between the set is too
large.
• Reduce the distance or angle.
The type plate is located on the base of the set.
J
18