Philips MCM25037 - Manual (Page 17)

ClockyTimer
Clock setting
1 In standby mode, press and hold CLOCK.
The clock digits for the hours flash.
2 Press VOLUME +/— to set the hours.
3 Press CLOCK again.
The clock digits for the minutes flash.
4 Press VOLUME + / — to set the minutes.
5 Press CLOCK to confirm the time.
Timer setting
# The system can be used as an alarm clock,
whereby the CD,TUNER orTAPE is switched on
at a set time.The clock time needs to be set first
before the timer can be used.
# You can also use it to record a favourite tuner
programme at a set period (refer to “Recording
timer")
# During setting, if no button is pressed within 90
seconds, the system will exit timer setting mode
automatically.
1 In standby mode, press TIMER SET for more
than two seconds.
2 Press SOURCE repeatedly (or CD, TUNER,
TAPE on the remote control) to select the
sound source.
3 Press TIMER SET to confirm your desired
mode.
^ The selected source @ Q 0 is shown.
Display sequence scrolls "SET ON TIME" and 0
flashes. The clock digits for the hours flash.
4 Press VOLUME +/— to set the hours.
5 Press TIMER SET again.
-♦ The clock digits for the minutes flash.
6 Press VOLUME +/-■ to set the minutes.
7 Press TIMER SET to confirm the time.
^ The timer is now set and activated.
Activating and deactivating tinner
# In standby or during playback, press TIMER
once on the remote control.
-♦ Display shows 0 if activated, and disappears if
deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.The clock time
needs to be set first before the sleep timer can
be used.
1 Press SLEEP on the remote control repeatedly
to select a preset time.
The selections are as follows (time in
minutes);
60-45-3015-0FF-60 ...
"SLEEP XX" or "OFF" is displayed. "XX" is the
time in minutes.
2 When you reach the desired length of time, stop
pressing the SLEEP button.
■4 Once SLEEP is activated, "SLEEP ON" scrolls
across the display at repeated intervals.
To deactivate the sleep timer
# Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
I
n
pg 001-020/M250/21-Eng 4/16/02, 7:05 PM
17
3140 115 29261