Philips MCM25037 - Manual (Page 11)

Basic Functions
Volume control
Press VOLUME +/ ““ to increase or decrease
the volume level.
“♦ Display shows the volume level "UOLUME"
and a number from 0-32.
To switch off the volume temporarily
Press MUTE on the remote control.
Playback will continue without sound and
"MUTE" is displayed.
To restore the volume, press MUTE again or
increase the volume level.
I
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Switching the system on
Press STANDBY ON (!) or SOURCE.
The system will switch to the last selected
source.
Press CD, TUNER, TAPE or AUX on the
remote control.
-♦ The system will switch to the selected source.
Switching the system to standby
mode
Press STANDBY ON (!) on the system or
remote control.
If in recording mode, press ■ first
The volume level, interactive sound settings,
last selected source and tuner presets will be
retained in the player's memory.
Power-saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 15 minutes after a
disc or tape has stopped playing.
Sound control
Press DSC repeatedly to select the desired
sound effect: OPTIMAL, ROCK, JAZZ or POP.
Press IS/DBB to switch on or off the surround
sound effect or bass enhancement.
The sequences are as follows ;
INCR.SURR. - DBB - DBB+INCR.SURR.
-OFF
^ If the DBB is activated, dbb is shown.
-♦ If the IS is activated, incr . surr is shown.
Note:
- The effeaofINCREDIBLE SURROUND may
vary with different types of music.
11
pg 001-020/M250/21-Eng 4
-
7:04 PM 3140 115 29261