Philips FB209W-17 - Manual (Page 7)

CONTROLS
_w
Transmitter
1 Status light......................... RED: Transmitter is on.
BLINKING: Transmitter is on and
input level is too high (see 5).
OFF: Transmitter is in standby
mode or is not connected to the
AC/DC adapter.
2 L(SUB) .................. ........... Not used with the supplied
configuration.
3 R(SURR) ................ .......... To connect the transmitter unit to
the SURROUND OUT (SURRPRE
OUT) jack of your set.
4 SURR / MULTI ................. Set this selector to SURR, the
position MULTI is not used with
the supplied configuration.
5 A-B'C ..................................To set the input sensitivity of
the transmitter unit.
A: maximum sensitivity
B: medium sensitivity
C: minimum sensitivity
6 14V...........
7 CHANNEL.
..............Connect the provided AC/DC
adapter here.
..............7 step channel selector for
setting the channel in case of
interferences.
Note: - Always be sure that the transmitter unit and the active
surround speaker are switched to the same channel,
otherwise no sound or only a distorted sound will be
heard on the surround speakers.
- Cellular phones used near the system (1-2 meters)
may interfere with the transmission.
- You have to switch off the active surround speaker
before setting the transmitting channel.
Active surround speakers
8 ©........................................ GREEN LIGHT: If this is on, the
active speaker is on.
9 (!)........................................ RED LIGHT: If this is on, the
active speaker is in standby
mode.
Note: - If both lights are off the active speaker is switched
off or is not connected to a power source.
10 CHANNEL ..........................7 step channel selector for
setting the channel in case of
interferences.
11 POWER ............................ .To switch the active surround
speaker on and off.
12 MAINS ...............................To connect the active surround
speaker to the power source.
The set complies with the FCC-Rules, Part 15.
Operation is subject to the following two conditions:
1. This device may not cause hannful interference, and
2. This device must accept any interference
received, including interference that may cause
undesired operation.