Philips FB209W-17 - Manual (Page 10)

GENERAL INFORMATION TECHNICAL DATA
m
3
3'
Power handling Technical data
Any amplifier or receiver used at high power can produce
distortions which may seriously damage your speakers. If
distortion occurs, reduce the volume and the tone control to a
level where the sound is acceptable again.
When using microphones, avoid feedback which occurs when
a microphone picks up sound from the speakers, resulting in a
howling noise. Keep the microphone away from the speakers
or reduce the volume.
Maintenance
A chamois leather slightly moistened with water is sufficent
for cleaning the speater cabinet. Do not use cleaning agents
containing alcohol, spirits, ammonia or abrasives.
Do not leave the speakers for a long time in direct sunlight or
other places where high temperatures can occur.
Do not expose the speakers to humidity or rain.
More wireless products...
The transmitter is also equipped to drive an optional wireless
subwoofer, wireless stereo speakers or wireless headphones.
Please ask your dealer about these products. Refer to the
instructions provided with these products before using them
with your transmitter.
Subject to change without notice
Surround speakers
Impedance............................................................................... 3£2
Frequency range......................................................100-15,000Hz
Output power.....................2 X 22 W RMS’/3i2/1kHz/THD 10%
Sensitivity...............................................................................87dB
Drivers..................................................................1 X 4" full range
Dimensions (h
x w x d)................................. 219 x 174 x 209mm
Weight...........................................................................approx. 3kg
’'±ldB
Magnetically shielded center speaker
Impedance.............................................................................. 12i2
Frequency range........................................................75-20,000Hz
Power handling capacity........................................................ 50W
Sensitivity...............................................................................89dB
Drivers.....................................2 X 4" woofers, 1 x 1 Vi' tweeter
Crossover frequencies...................................................... 8,000Hz
Dimensions (h x w x d)................................. 152 x 400 x 160mm
Weight.......................................................................approx. 3.4kg
Transmitter
System........................................................... Radio frequency (RF)
Modulation........................................ Frequency modulation (FM)
S/N in signal........................................................................... 95dB
Step channel frequency..............................913.750-915.250MHz
Transmission power...........................................................< lOmW
Working range...............................................................up to 100m
Dimensions (h x w x d)................................. 206 x 130 x 134mm
Weight.....................................................................approx. 0.26kg
10