Philips FB209W-17 - Manual (Page 11)

TROUBLESHOOTING
WARNING
If a fault occurs, first check the points listed below before
taking the speakers for repair.
Under no circumstances should you try to repair the
|f ypy g|-g
|jn 3 t)|e to solve a problem by following these hints,
speakers yourself, as this will invalidate the warranty. consult your dealer or sen/ice center.
PROBLEM POSSIBLE CAUSE SOLUTION
No sound VOLUME is not correctly adjusted. Adjust the VOLUME.
Headphones are connected to the appliance. Disconnect headphones.
Speakers are not (or wrongly) connected. Connect the speakers securely.
No sound on the One speaker is wrongly connected. Connect the speaker properly.
left or right side
A speaker cable is damaged. Replace the cable.
Poor sound or no sound at SURROUND mode is not switched on. Switch to the surround mode on the appliance.
the center or surround
speakers
Surround and/or center speakers are not
(properly) connected. Connect the speakers properly.
A speaker cable is damaged. Replace the cable.
Transmitter or active surround speakers are
switched off.
Switch on transmitter and active surround
speakers.
Transmitter and/or active surround speakers
are not securely connected to the power
source.
Connect the power cables properly.
CHANNEL slides of the transmitter and
the active speakers are not switched to the
same number.
Set the CHANNEL slides on the transmitter and
on both active speakers to the same number.
Transmitter is connected to the wrong
terminal on the appliance.
Connect the transmitter to the correct terminal
on the appliance.
SURR/MULTI switch of the transmitter
is in the wrong position. Set the SURR/MULTI switch to the SURR
position.
The signal from the transmitter is interferred
through electric appliances. Set the transmitter and the actjve surround
speakers to another transmitting channel.
The signal from your appliance is too strong. Set the input sensitivity of the transmitter to
the next level.
Poor bass sound Speakers are not in phase. Connect speakers properly; colored cable to
©-pole, black cable to 0-pole.
Bad sound Setting does not match for the given type of
music or sound. Correct the sound settings on the appliance.
Surround sound level is
too low or too high
The level of the surround sound is not
properly adjusted.
Adjust the level and delay time of the
surround sound on the appliance.
Center sound level is too
low or too high The sound level of the center channel is not
properly adjusted.
Adjust the level of the center channel
on the appliance.
M
en
e
11