Philips CDC751-17 - Manual (Page 5)

INSTALLATION
POWER SUPPLY SETTING CONNECTIONS
• Check that the type plate on the rear of your changer
indicates the correct supply voltage.
• If your mains supply voltage is different, consult your dealer
or our Service Organisation.
Certain versions of this changer are equipped with a voltage
selector 4, which enables you to set the player to the correct
mains voltage yourself. When changing the voltage setting, it is
also necessary to change the mains fuse 3 to one of the correct
rating: T200 mA (slow blow fuse) for 110/127 V;
T100 mA (slow blow fuse) for 220 V - 230 V/ 230 V - 240 V.
SITING THE COMPACT DISC CHANGER________________
Free standing
• Always position the changer horizontally on a flat, firm surface.
• Allow a free space of at least 3 cm above the changer so as
not to interfere with the cooling of the changer.
In an audio rack
• The changer can be sited in any desired position.
Stacked
• Site the changer preferably at the bottom or at the top.
• Never position the changer directly on top of a high-power
amplifier, as such an amplifier gives off a substantial amount
of heat.
ANALOG OUT
For the connecting cable to the amplifier.
• Insert a red plug into the 'R' socket and the
other plug into the 'L' socket.
• Insert the two other plugs into the corresponding sockets of
the CD or AUX input of your amplifier.
You can also use the TUNER or TAPE IN connection, but
neverthe PHONO input!
2 RC 5 (CDC 741 only)
For connecting up the equipment in a Philips HiFi system
with its own remote control system.
The CDC 741 can then be operated via the remote control
of the system.
3 Mains fuse holder (not all versions)
See 'POWER SUPPLY SETTING'.
4 Voltage selector (not all versions)
See 'POWER SUPPLY SETTING'.
CONNECTING HEADPHONES (CDC 751 only) ____________
• Connect headphones
with a 6.3 mm jack plug to the
PHONES socket 10.
• The sound level is adjusted with the
LEVEL control 11.