Clarion RMX465D - Manual (Page 8)

10
RMX465D
7. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power
is off. In some cars, the clock may momen-
tarily disappear when the ignition key is
turned to the START position. The clock will
reappear after the engine has started and the
ignition key is released to the IGN (ignition-
on) position.
Turning on/off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Press POWER button 3 .
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold POWER button 3 for 1 sec-
ond or longer to turn off the power for the unit.
Selecting a mode
1. Press FNC button 3 to change the mode of
operation.
2. Each time you press FNC button 3 , the mode
of operation changes in the following order:
Radio mode ➜ MD mode ➜ CD changer
mode ➜ TV mode ➜ Radio mode...
∗
External equipment not connected with C-BUS
is not displayed.
Adjusting the volume
Turning the Rotary volume knob $ clockwise
increases the volume; turning it counterclockwise
decreases the volume.
∗
The volume level is from 0 (minimum) to 33 (maxi-
mum).
Switching the display
Press DISP button 5 to select the desired display.
Each time you press DISP button 5 , the display
switches in the following order:
Main display
Clock display
∗
Once selected, the preferred display becomes
the display default. When a function adjustment
such as volume is made, the screen will
momentarily switch to that function’s display,
then revert back to the preferred display sev-
eral seconds after the adjustment.
Setting the Z-enhancer
This unit comes with 3 types of sound tone effects
stored in memory. Select the one you prefer.
∗
The factory default setting is “Z-EHCR OFF”.
Each time you press Z-EHCR button ! , the tone
effect changes in the following order:
“Z-ENHANCER 1” ➜ “Z-ENHANCER 2” ➜ “Z-
ENHANCER 3” ➜ “Z-EHCR OFF” ➜ “Z-
ENHANCER 1”...
• Z-ENHANCER 1 : bass emphasized
• Z-ENHANCER 2 : treble emphasized
• Z-ENHANCER 3 : bass and treble emphasized
• Z-EHCR OFF : no sound effect
Adjusting the tone
Press A-M button 2 and select the item to adjust.
Each time you press A-M button 2 , the item
changes in the following order:
BASS ➜ TREB ➜ BAL ➜ FAD ➜
Previous mode…
➜