Philips PR1909B - Manual (Page 3)

H ooking U p
Y our TV (A ntenna /C able C onnections ) (C ont ’ d )
VCR TO TV
I—
CBEGIN>
■ <3>
B asic C onnection
T he basic Antenna/Cable to
VCR to TV connection is
shown here. If you have a Cable
Box, refer to the VCR owner’s
manual for details.
Connect your
Antenna or Cable signal to
the IN FROM ANT(enna)
jack on the VCR.
Connect a coaxial
cable to the OUT TO
TV jack on the VCR
and to the ANT(enna)
IN jack on the TV.
The coaxial cable may be
supplied with the VCR.
Refer to the VCR
owner's manual for other
possible connections and for
operating details.
Outdoor VHF/UHF
Antenna
300 to 75Í2 Adaptor
C able TV I------CBEGIN)-
C able /C able B ox
y bur Cable TV signal may be
a single (75fl) cable or a
Cable Box installation. In either
case, the connection to the TV is
very easy.
<ï>,
If you do not have a
Cable Box, then you're ready
to connect your Cable TV sig­
nal to the TV.
If you have a Cable Box:
Connect the Cable TV signal to
the IN jack on the Cable Box.
Connect the Cable TV sig­
nal to the ANT(enna) IN jack
on the TV.
If you have a Cable Box:
Use a coaxial cable to connect
the OUT jack of the Cable Box
to the ANT(enna) IN jack on
the TV.
NOTE: The coaxial cable might
be supplied by the Cable TV
company.
To select
only the channels on
your Cable system,
see First Time Setup
(page 4). If you use a
Cable Box, set the
TV to the same
channel as the CH
3/4 switch on the
back of the Cable
Box.
Note to the Cable TV System Installer: This reminder is provided to call
the Cable TV system installer’s attention to Article 820-40 of the National
Electrical Code, which provides guidelines for proper grounding - in particular,
specifying that the cable ground shall be connected to the grounding system
of the building, as close to the point of cable entry as possible.
Cable TV Company
- 3 -