OmniSistem Beta 3 – EC-2600U - Manual (Page 9)

|< >| 7
To assure the use security by using an external computer(need to install control software of this processor), you
can disable RECALL and REMOTE/ID operation with the unit, and then LOCK indicator lights up.
You can operate without using an external computer to LOCK and release LOCK of the unit
To LOCK
1). Turn off the power,
2). Turn on the power with keeping pressing UP button.(Sound is not output),
3). LOCK lights up while digital transistor display normal No., move away your hand from UP ,
Auto panel operation is prohibited and come to normal working status.
To release LOCK
1). Turn off the power
2). Turn on the power with pressing DOWN button.
3). LOCK lights down while digital transistor display normal No., move away your hand from
DOWN, Auto panel operation open and come to normal working status.
RECALL of stored programs with the unit is as follows,
1). Press RECALL/ENTER button while while PROGRAM indicator lights up.
Then the currently set program number flashes and each output channel
indicator turns to flash simultaneously, meaning that it is ready for setting
output status.(Program will not be changed until step 3),
2). Select program number you to RECALL output indicating the program
arrangement information with UP and DOWN,
3). Press RECALL/ENTER button.The program number will stop flashing and
display the newest programs' Number.
7.2 Indications and operation at LOCK
7.3 Display and operation during linking to computer
You cannot use buttons on the front panel while you control with an external
computer. In this case, indicator of LOCK at DISPLAY mode indicator light up.
The number of the display indicates the current program number.
PROGRAM
STATUS
REMOTE/ID
LOCK LOCK
Attention:
1). You can press DISPLAY button to cancel while digital transistors display, the mode will be back to the normal
status before starting RECALL,
2). Program NO. inside without save will not display,
3). RECALL operation is impossible if you press RECALL/ENTER when there is no RECALL-capable program.
Also, any stored programs which are set RECALL LOCK are never displayed. (use an external computer to
set and release RECALL LOCK.),
4). When the LOCK indicator is lit, RECALL operation is impossible.
7.4 RECALL : Transferring program
RECALL
/ENTER
DOWN UP
RECALL
/ENTER
RECALL
/ENTER
DIGITAL SPEAKER PROCESSOR