OmniSistem Beta 3 – EC-2600U - Manual (Page 5)

|< >| 3
3> UNPACKING
As a part of our system of quality control, every product is carefully inspected before leaving the factory to ensure
flawless appearance. After unpacking, please inspect for any physical damage. Save the shipping carton and all
packing materials, as they were carefully designed to minimize the possibility of transportation damage should the
unit again require packing and shipping. In the event that damage has occurred, immediately notify your dealer so
that a written claim to cover the damages can be initiated. The right to any claim against a public carrier can be
forfeited if the carrier is not notified promptly and if the shipping carton and packing materials are not available for
inspection by the carrier. Save all packing materials until the claim has been settled.
4> AC POWER REQUIREMENTS
Note:
The 115V/230V switch is built in the DEVICE to avoid damage caused by wrong operation. The default set is 230V
before leaving factory. If the local voltage is 115V,please open the cover and set the switch at 110V under
disconnecting the ac. If the fuse is damaged, please replace the same type and rating fuse.
Instruction:
The show on the switch is standard. As above diagram, the show is 230V on switch, it means the current
ac voltage is 230V.
DIGITAL SPEAKER PROCESSOR