OmniSistem Beta 3 – EC-2600U - Manual (Page 8)

|< >| 6
7> DISPLAY AND OPERATIOIN
When PROGRAM is lit:
The number display indicates the current program number and each output channel
indicator indicates output level at that output;
When OUTPUT STATUS is lit:
The number display indicates the current program number and each output channel
indicator indicates output assignment status.
When REMOTE/ID is lit:
The number display indicators REMOTE ID number and each output channel indicator
indicates the level.
OUTPUT INPUT
MUTE
DOWN
UP
DISPLAY
RECALL
/ENTER
MUTE MUTE MUTE MUTE MUTE MUTE MUTE
-6
-10
-20
-40
COMP
OVER
LOCK
IN-1
IN-2
HF
MF
LF
SLF
LIMITER
OVER
-6
-10
-20
-40 SLF
LF
MF
HF
IN-2
IN-1
-40
-20
-10
OVER
LIMITER IN-1
IN-2
HF
MF
LF
SLF
LIMITER
OVER
-6
-10
-20
-40 SLF
LF
MF
HF
IN-2
IN-1
-40
-20
-10
-6
OVER
LIMITER IN-1
IN-2
HF
MF
LF
SLF
LIMITER
OVER
-6
-10
-20
-40 SLF
LF
MF
HF
IN-2
IN-1
-40
-20
-10
-6
OVER
LIMITER
-6
PROGRAM
STATUS
REMOTE/ID
2 1 C B A D E F
POWER
Beta Three
7.1 Switching display mode
You can change the display mode by pressing the display button in turn.
The Display mode indicator shows the current display.(Not available during
external control)
PROGRAM
STATUS
REMOTE/ID
LOCK LOCK
IN-1
IN-2
HF
MF
LF
SLF -40
-20
-10
-6
OVER
LIMITER
A
IN-1
IN-2
HF
MF
LF
SLF -40
-20
-10
-6
OVER
LIMITER
A
Output level indication:
Indicates signal levels of each output after all signal processing.
Output level correspond to the level scale printed at the left side of the indicator.
When OVER is lit for a long time: means that the signal is too big, can lower the input
signal;
When LIMITER is lit: means the compressor is working.
Indicates simply which output channel is fed by which input channel and the output
frequency range based on the setting of filter cut-off frequencies.
This function helps prevent speaker from being damaged as you can make sure of each
output's status when you operate RECALL or connect an amplifier and loudspeaker.
The print at the right side of the LED show each indication's meaning as follows:
IN-1,IN-2
Indicates which input's signal is the sound source. When both indicators
light up, it indicates monomixed signal is the sound source.
HF,MF,LF,SLF
Indicates the frequency range of each output channel:
HF : High Frequency; Lights up when frequen cies>=1KHz;
MF : Middle Frequency; Lights up when frequencies from 500Hz to 1KHz;
LF : Low Frequency. Lights up when frequencies from 100Hz to 500Hz;
SLF : Super Low Frequency; Lights up when frequencies<=100Hz.
Output status indications:
DIGITAL SPEAKER PROCESSOR
DIGITAL SPEAKER CONTROLLER
C-2600U
R