OmniSistem PR Pilot 575 - Manual (Page 9)

Pilot 575 Manual_ Last Revision_En.doc 9/22
Lock Tilt.
Free 2 latch catches on the cover and slip off the front cover. You could see the structure as shown in
the above figure.
For gobos replacement on the rotated gobo wheel: take an appropriate tool to tug up spring and take
out the rotating gobo with its holder; tug the head of retaining spring up and engage your another
hand to take the retaining spring out; take the gobo out; fit a new gobo and fit the retaining spring; fit
the lampholder. Notes: the gobo cannot be touched with bare hand; be careful of the gobo when the
replacement is underway and don’
t drop it.
For gobos replacement on the fixed gobo wheel: turn the rotated gobo wheel to a proper position first;
take out a gobo from the fixed gobo wheel carefully; fit a new gobo. Note: if the gobo is a glass one, it
should be touched with glabrous, clean and soft tissue or cloth matted between hand and glass
instead of with bare hand.
Close the front cover and fasten 2 latch catches.
Pan’ s belts
Free 2 screws on Pan assembly’ s maintenance
door and open the door; change the belts;
close the door and fasten the screws.
Tilt’ s belts
The common users replacing the belts is not
recommended.
REPLACING GOBOS
CHANGING BELTS
Open the door
Screws
Base