Dmx control channel functions, Maintenance – OmniSistem PR Pilot 250 Wash User Manual
Page 8
DMX CONTROL CHANNEL FUNCTIONS
The PILOT WASH uses 10 DMX channels. They are listed in the following table.
CHANNEL DMX
VALUE
DESCRIPTION
1
Magenta
0-255
From light magenta to dark magenta
(5-7) Setup options and address reset
2
Yellow
0-255
From light yellow to dark yellow
3
Cyan
0-255
From light cyan to dark cyan
0-10 Black-out
11-127
Open gradually from shut to full open (dimming)
128-252
Strobe movement from slow to fast
4
Shutter/Strobe
253-255 Open
5
Pan
0-255
Pan movement from 0° to 352°
6
Tilt
0-255
Tilt movement from 0° to 250°
0-27 White
28-54 Red
55-81 Yellow
82-109 Orange
110-136 Green
137-163 Blue
164-191 Ultraviolet
7
Colour Wheel
192-255
Colours change from slow to fast till rainbow effect
0-31 Open/Clear
32-223
Ribbed glass stepping rotative movement
8
Effects Wheel
224-255 Frost
glass
9 Pan 16bit
0-255
16 Bit Pan resolution
10 Tilt 16bit
0-255
16 Bit Tilt resolution
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes
damaged or deformed in any way it must be replaced. If the light from the lamp appears dim this would
normally indicate that it is reaching the end of its life and it should be changed at once, old lamps run
to the extremity of their life can explode. If the projector does not function, check the fuses on the
power socket of the projector, they should only be replaced by fuses of the same specified value
6.3A/250V (fast blow, 5mmx20mm). On the main PCB inside the projector there is also a fuse rated
4A/250V (fast blow, 5mmx20mm). Should these be damaged call a qualified technician before
replacement. The projector has 2 thermal protection devices that will switch off the projector in case of
overheating, should either of these operate, check that the fans are not blocked, and if they are dirty
clean them before switching on the projector again. Check that the
fans are operational, if not call a
qualified technician.
Any maintenance work should only be carried out by qualified technicians.
Pilot Wash manual.doc
8/12